Time zones

Process engine

The CIB seven engine uses the default time zone of the JVM when operating with dates:

When reading datetime values from BPMN XML
In REST responses
When reading/writing DateTime values from/to the database

Database

Database time zone and database sessions time zone are out of scope of the CIB seven engine and must be configured explicitly.

However, Timestamp columns in the CIB seven engine are using the TIMESTAMP [WITHOUT TIME ZONE] data type (the name differs in different database servers). For this reason, it is not recommended to change the time zone on the database side once set, since it may lead to an incorrect operation of the CIB seven engine.

Daylight Saving Time

Timezone information is not saved in the timestamp columns. In order to avoid ambiguous timestamps, it is recommended to use a timezone like UTC as the JVM’s default timezone that is not adjusted for Daylight Saving Time (DST) and therefore cannot produce ambiguous timestamps.

If this is not an option in your setting, please consider disabling the JobExecutor during the DST switch in order to avoid unexpected job executions.

Camunda Web Applications

It is possible to use the Camunda Web Applications in different timezones. All dates are translated to/from the local timezone when working with the UI.

Cluster Setup

In case the process engine is running in a cluster, all cluster nodes must run in one and the same time zone. In case cluster nodes exist in different time zones, correct behaviour when operating with DateTime values can not be guaranteed.